High Elongation PU Waterproof Coating Two Component For Crack Bridging

High-elongation Two-component Polyurethane Coating For Crack-bridging

Advantages for Bathroom

1. High film elasticity: High tensile strength and elongation, resists thermal expansion‑contraction and micro‑cracks of substrate, prevents water‑leakage caused by floor slight deformation.
2. Seamless waterproofing: Reactive liquid‑formed film fully covers corners, pipe roots and floor drains without joints, reduces leakage risk at high‑risk positions.
3. Strong adhesion: Firm bonding to cement‑mortar substrate, less hollowing, blistering and delamination.
4. Long‑term water immersion resistance: Stable performance under long‑time soaking, ideal for shower area waterproofing.
5. Mildew & corrosion resistance: Adapt to hot‑humid bathroom environment, resist sewage corrosion.
6. Excellent water‑pressure resistance: Dense film with strong impermeability to stop water seepage to lower floors.
7. Good for detail treatment: Extra‑thick coating around pipe roots and floor drains to reinforce high‑leakage‑risk zones.
8. High mechanical strength: Cured rubber‑like film resists impact, hard to damage during tile‑laying work.

Application Method for Bathroom

1. Substrate preparation: Keep bathroom floor & wall solid and flat. Remove dust, oil and loose mortar. Plug holes and repair cracks. Keep substrate dry without standing water.
2. Detail reinforcement: Apply 1‑2 coats of two‑component polyurethane as extra layer for pipe roots, floor drains and corners, width ≥250mm per side. Proceed to main‑area construction after drying.
3. Proportion & mixing: Weigh component A and B strictly by weight ratio. Electrically stir for 3‑5 minutes until uniform without particles. Use mixed material within pot‑life, do not dilute with water.
4. Multi‑layer trowel application: Apply thin coats repeatedly; single heavy coat is forbidden. Apply next coat after previous coat dries, brush in cross directions. Total film thickness for floor ≥1.5mm; shower‑zone wall height ≥1.8m, other walls ≥300mm.
5. Curing: Natural full curing. Forbid treading and water contact during curing period.
6. Water‑storage test: Carry out 24‑48 hours water‑storage test after full curing. Pass test if no leakage downstairs.
7. Protective layer & tile work: Apply cement‑mortar protective layer after qualified water test, then lay ceramic tiles.

high elongation pu waterproof coating

pu waterproof coating two component

high elongation polyurethane waterproofing coating

High Elongation PU Waterproof Coating Two Component For Crack Bridging Images